2How To Verify That Your Keykode Is Updating The Edge Numbers; How To Verify That Your Keykode Is Updating The Edge Numbers; 3Displaying Status Information From The Film Barcode Reader; Displaying Status Information From The Film Barcode Reader - evertz 4025 Instruction Manual

OPERATION
3.11.2 How to verify that your KeyKode is Updating the Edge
Numbers
When using an external barcode reader it is important to know if the edge
numbers being displayed in the 4025 are being updated from the barcodes,
or only from the telecine bi-phase. The KK CHECK item on the Format
menu enables a visual indicator in the character inserter when the
KeyKode is not updating.
Press the FORMAT key to access the Format menu. Using the
keys drop down the FILM menu. Use the
CHECK menu item and press the SELECT key to show the KK CHECK
sub menu. The currently programmed KeyKode check mode is shown in
reverse video. Press the
the FORMAT or CLR keys to exit the format menu, or press the SELECT
key to return to the FILM drop down menu.
With KEYINFO CHECK the 4025 will change the font of the Key info part of
the film edge number window when 4025 detects that the barcode
information is missing, and the edge numbers are being updated only by
the telecine bi-phase. In the Tiny character size, the Key Info part of the
edge number will be shown in inverse video. Barcode missing is detected
when no barcode information has been received for the number of feet of
film travel set in the CHECK DELAY parameter, or KK JAM is set to
NEVER. With KEYINFO ON the font of the key info will be the same as the
rest of the numbers. With KEYINFO OFF the key info will be blanked and
only the footage and frames will be displayed.
information on setting the CHECK DELAY).
It is highly recommended that you operate the 4025 with KEYINFO CHECK

3.11.3 Displaying Status Information from the Film Barcode Reader

The Film Barcode status information display is controlled from the
KKSTATS item of the Toolbox DEBUG menu. There are five pieces of
information contained in the status line which can be used to verify correct
operation of the Film Barcode reader. This display is updated at each
barcode read.
PERF Shows the perf type (the perf that the barcode reference dot
lines up with), of the currently running film stock. This value
may change if a splice is encountered or if the 4025's film
centering is wrong. On 35 mm film, perf 1 is at the head of the
frame, perf 4 is at the tail of the frame. On 16 mm film the perf
value is not applicable.
Model 4025 Film Footage Encoder Manual
& keys to select the desired mode. Press
PERF:1 ERR:00 SCAN:+00 PULL:C KJ
& keys to highlight the KK
(See section 3.7.3 for
Page 56
&