Rank Cintel Ursa - evertz 4025 Instruction Manual

INSTALLATION
pins 3 & 7 of the 9 pin parallel I/O D connector. Connect ground to pin 6 on
the rear of the 4025. Retain the separate shielding of each signal up to the
4025 in order to prevent cross-coupling which can adversely affect the bi-
phase reliability.
Remove the coax cable connected to the Frame BNC (BSK 20) on the
telecine Digiscan frame, (if any) and connect it to one side of the FILM
FRAME loop on the 4025. Connect the other side of the FILM FRAME
loop to the Frame BNC (BSK 20)
Do not terminate this signal.
The telecine type item on the Engineering Toolbox Hardware Menu must
be set to RANK.
Hardware Menu must be set to either LATCHED or SAMPLED.
section 3.6.4 and 3.6.5) In NTSC configurations, the film rate setting on
the FILM drop down menu may be set to Auto, 24 or 30 FPS. (See section
3.4.4 or 3.10.9)
Do not use AUTO rate detect when using a Time Logic Controller and Rank
Cintel 4:2:2 telecines.

2.10.5. Rank Cintel URSA

The Bi-phase tach pulse is available on a pair of BNC connectors on the
rear of the Mag follower. These bi-phase signals must be connected to
pins 3 & 7 of the 9 pin parallel I/O D connector. Connect ground to pin 6 on
the rear of the 4025. Retain the separate shielding of each signal up to the
4025 in order to prevent cross-coupling which can adversely affect the bi-
phase reliability.
Remove the coax cable connected to the Frame BNC (BSK 33) on the
telecine Digiscan frame, (if any) and connect it to one side of the FILM
FRAME loop on the 4025. Connect the other side of the FILM FRAME
loop to the Frame BNC (BSK 33)
Do not terminate this signal.
The telecine type item on the Engineering Toolbox Hardware Menu must
be set to RANK.
Hardware Menu must be set to either LATCHED or SAMPLED.
section 3.6.4 and 3.6.5) In NTSC configurations, the film rate setting on
the FILM drop down menu may be set to 24 or 30 FPS. (See section 3.4.4
or 3.10.9)
Model 4025 Film Footage Encoder Manual
The film frame item on the Engineering Toolbox
The film frame item on the Engineering Toolbox
(See
(See
Page 2-17