Table of Contents
Advertisement
2.
INSTALLATION
2.1.
REAR PANEL
CHAR. GEN
OUT
VIDEO
IN
4015
INSTALLATION
GENERATOR
LTC OUT
FILM
FRAME
-I/O-
SERIAL
PARALLEL
Figure 2-1: Rear Panel
The following sections describe the purpose of the rear panel connectors of
the 4025. Figure 2-5 to Figure 2-9 give sample connection diagrams for
various common configurations. Sections 2.7 to 2.11 describes the specific
generator, reader, character inserter, and telecine signals that should be
connected to the 4025.
Evertz 4015 users who are upgrading to 4025 units will be familiar with most
of the connections. Most of the connections are the same as for the model
4015. Pay particular attention to alerts identified with the symbol shown at
the left.
2.1.1. Generator Connectors
LTC OUT
Figure 2-2: Generator Rear Panel Connectors
LTC OUT: A Male XLR connector for output of SMPTE/EBU longitudinal
time code from the generator.
GEN VIDEO IN: A BNC loop for input of program video onto which vertical
interval time code will be inserted. This signal is required for
proper gen-locking of the Model 4025 VITC Generator.
VITC OUT: Two BNC outputs of program video with vertical interval time
code inserted.
Model 4025 Film Footage Encoder Manual
READER
A
LTC IN
B
GEN
AUX I/O
VITC OUT
VIDEO IN
GENERATOR
FILM
FRAME
-I/O-
SERIAL
PARALLEL
VITC IN
A
B
GEN
VITC OUT
VIDEO IN
Page 2-1
FUSE
115V:
.25 A
230V:
.125 A
Advertisement
Table of Contents
