evertz 4025 Instruction Manual page 81

OPERATION
Figure 0-6: Register Status Indicators
KKODE Indicates that a valid KeyKode data record has been received
from an external KeyKode reader system.
normally be on when KeyKode data is being received and is
updating the edge numbers. It will blink for each KeyKode data
packet received when the Edge numbers are not being updated.
This usually indicates that the head offset has not been learned,
or that KK JAM is set to NEVER. The KKODE LED will also
blink when a keykode discontinuity is detected by the 4025.
RDR 1 Indicates that Reader 1 is reading valid time code.
RDR 2 Indicates that Reader 2 is reading valid time code.
EVENT 1 READY
armed. When it is on solid, it indicates that the Event 1 register
has triggered an event.
EVENT 2 READY
armed. When it is on solid, it indicates that the Event 2 register
has triggered an event.
Model 4025 Film Footage Encoder Manual
When blinking it indicates that Event 1 register is
When blinking it indicates that Event 2 register is
This LED will
Page 15