Table of Contents
Advertisement
3.6
PROGRAMMING THE HARDWARE CONFIGURATION - THE HARDWARE MENU
OPERATION
film frame, on line number 11. Consult the operating manual for
your disc recorder to make sure that you are using the correct
line(s) for the white flag pulse.
The HARDWARE menu of the Toolbox menu is used to configure various
hardware related items of the 4025 such as character width, display
brightness, Telecine Type, Bi-phase Rate, etc. Press SHIFT+FORMAT to
enter the Toolbox menu system. See section 3.2.1 for an overview of the
Toolbox menu system.
3.6.1
Adjusting the Horizontal Character Size
HORZ CHAR SIZE
keys to adjust the right side of the raster
3.6.2
Adjusting the Front Panel Display Brightness
DISPLAY LEVEL
display. Use the
3.6.3
Selecting the Telecine Bi-Phase Rate
BI PHASE RATE
film frame. See section 2.10.2 or 2.11.2 for information about
connecting bi-phase from your telecine.
In some early versions of the 4025 firmware DIP Switches #3 & 4 on the 615
module were used to set the bi-phase rate.
purposes now and should be set in accordance with the figure 6-6 in section
6.3.7.
3.6.4
Selecting the Telecine Type
TELECINE TYPE
See section 2.10.2 or 2.11.2 for information about connecting
the frame pulse from your telecine.
In some early versions of the 4025 firmware DIP Switch #7 on the 615 module
was used to select between RANK and BTS type telecines. It is now used for
other purposes and should be set according with the chart in Figure 6-6.
Make sure the appropriate frame pulse is connected to the 4025.
(See section 2.10.2 or 2.11.2 of the 4025 manual.)
Make sure the FILM FRAME SETTING is set correctly for the telecine type
you are using.
Model 4025 Film Footage Encoder Manual
Is used to adjust the character width. Use the
Is used to adjust the brightness of the front panel
&
keys to adjust.
Is used to select the number of bi-phase pulses per
Is used to select the type of telecine you are using.
They are used for other
Page 32
&
Advertisement
Table of Contents
