Mounting - Busch-Jaeger SD/U12.55.11-825 Manual

6.5.3

Mounting

Fig. : Mounting with cover frame
Mounting with cover frame is possible with the following displays:
SD/U12.55.11-825 2.4" Display Balance
■
SD/U12.63.11-825 2.4" (6.10 cm) Display 63
■
SD/U12.70.11-4015 2.4" Display Nova
■
Fig. 14: Mounting with cover fame
For mounting with cover frame the following steps are necessary:
1. Install the support ring [1] .
2. Insert the device in the cover frame [2].
3. Connect the wires to the connecting terminals, See "Circuit diagrams" on page 28.
4. Snap the device [3] into the support ring [1] by hand.
– Observe the correct alignment [X]!
Notice
The arrows [X] on the back must point upwards.
The device is now fully mounted.
Product manual 2CKA001473B5472
1
2
X
X
Connection, installation / mounting
3
│33