Control Element: "Value Slider; Blind" Control Element; Control Element "Fan Switch; Scene" Control Element - Busch-Jaeger SD/U12.55.11-825 Manual

7.8.6

Control element: "Value slider"

The values of a selected element (group address) can be displayed and at the same time
adjusted via the slider using the "Value slider" control element. When adjusted, the values are
displayed directly updated. This allows values to be sent and received via this function.
Setting and selection options via the "Parameter" area of the DCA, see chapter 8.6 "Control
element: "Value slider"" on page 97.
7.8.7

"Blind" control element

A blind control can be set up via the "Blind" control element. This allows an allocated blind to be
operated.
Setting and selection options via the "Parameter" area of the DCA, see chapter 8.7 ""Blind"
control element" on page 103.
7.8.8

Control element "Fan switch"

A fan control can be set up via the "Fan switch" control element. This, for example, allows the
fan speed level to be changed for an allocated fan.
Setting and selection options via the "Parameter" area of the DCA, see chapter 8.8 "Control
element "Fan switch"" on page 107.
7.8.9

"Scene" control element

A scene can be allocated via the "Scene" control element. The scene starts when clicking on
this element, if this has been so defined. The scenes must first be created by the commissioner.
Setting and selection options via the "Parameter" area of the DCA, see chapter 8.9 ""Scene"
control element" on page 111.
7.8.10

Control element "RTC control element"

The "RTC control element" (extension unit) can be used to control an allocated room
temperature controller, for example.
Setting and selection options via the "Parameter" area of the DCA, see chapter 8.10 "Control
element "RTC control element"" on page 113.
Product manual 2CKA001473B5472
Commissioning of the KNX function via DCA
│61