Busch-Jaeger SD/U12.55.11-825 Manual page 147

Notice
The parameter is only available when the setting "As temperature input" is used
during the parameterization of binary input under "Use binary input".
Filter
■
Options:
The filter is selected via the parameter.
Notice
The parameter is only available when the setting "As temperature input" is used
during the parameterization of binary input under "Use binary input".
Send output value
■
Options:
– The parameter is used to select how the output value is sent.
The output value must change before sending [x0.1°C]
■
Options:
The parameter is used to select how the output value must change before sending.
Send the output value cyclic [SS:MM:SS]
■
Options:
The parameter is used to select the output value for cyclic sending.
Product manual 2CKA001473B5472
Control elements and application parameter
Notice
– The parameter is only available if the parameter "Line fault
compensation" is set on "Length".
Inactive
Low (mean value of 4 measurements)
Medium (mean value of 16 measurements)
High (mean value of 64 measurements)
Cyclic and during change
Only during change
Only cyclic
Setting option from 1 - 50
Notice
– The parameter is only available if the parameter "The output value
must change before sending" is set on "Only on change" or "Cyclic
and on change".
Setting option from 00:01:00 - 18:12:15
Application "Inputs"
│147