Busch-Jaeger SD/U12.55.11-825 Manual page 163

Value of output x:
Options:
This parameter is used to specify the value the communication object has on output x.
1 byte [0 - 100%]:
■
– The following parameter appears:
Value of output x:
■
Options:
This parameter is used to specify the value (in percent) the communication object has on output
x.
Notice
How many "Value of output x" parameters are displayed depends on the setting
of the "Outputs used" parameter.
Gate:
■
– This logic function can be used to filter certain signals and block the flow of signals
temporarily. The function has three communication objects: "Control input", "Input" and
"Output". The input or output can take on size 1 bit, 2 bit, 1 byte, 2 byte, 4 byte or 14
byte. The control can take place from input to output, from output to input and in both
directions. Enabling via the control input can take place via an ON or OFF telegram.
It can also be set as to whether the input signals are to be stored or not "during the blocking
phase". If the setting "Store input signals during blocking" has been selected and if a telegram
has been received on the input during the blocking phase, the output sends its value. The value
stored last is sent only after a renewed enable on the control input.
If the size of the input and output objects is 1 bit, the input can also be inverted. This allows an
inverting member to be implemented via a gate. It is also possible to block signals via the "Filter
function" setting. Either "Do not filter" or the signal "Filtered ON" or the signal "Filtered OFF" is
sent.
The following parameters are enabled:
Direction of data flow:
■
Options:
The parameter is used to specify the direction data are sent via the channel. See the
explanation above.
Sending an output telegram:
■
Options:
The parameter is used to specify when the output telegram is sent.
Product manual 2CKA001473B5472
Control elements and application parameter
0
1
Setting options from 0 - 100
Input -> Output
Output -> Input
Input <-> Output
At every receipt
At changed values
Application "Logical functions"
│163