Setpoint Adjustment - Maximum Manual Reduction During Heating Mode (0 - 9°C); Setpoint Adjustment - Maximum Manual Increase During Cooling Mode (0 - 9°C); Setpoint Adjustment - Maximum Manual Reduction During Cooling Mode (0 - 9°C); Setpoint Adjustment - Step Size Of Manual Setpoint Adjustment - Busch-Jaeger SD/U12.55.11-825 Manual

This preset can be used to limit the manual increase during heating.
Note
This parameter is only available when parameter "Controller function" is set
on "Heating" and parameter "Control value type" on "2-point 1 bit, On/Off" or
"2-point 1 byte, 0/100%".
8.18.95 Setpoint adjustment — Maximum manual reduction during heating mode (0 - 9°C)
Options:
This preset can be used to limit the manual decrease during heating.
Note
This parameter is only available when parameter "Controller function" is set
on "Heating" and parameter "Control value type" on "2-point 1 bit, On/Off" or
"2-point 1 byte, 0/100%".
8.18.96 Setpoint adjustment — Maximum manual increase during cooling mode (0 - 9°C)
Options:
This preset can be used to limit the manual increase during cooling.
Note
This parameter is only available when the "Control function" parameter is set on
"Cooling," "Cooling with additional stage," "Heating and cooling" or "Heating and
cooling with additional stages".
8.18.97 Setpoint adjustment — Maximum manual reduction during cooling mode (0 - 9°C)
Options:
This preset can be used to limit the manual decrease during cooling.
Note
This parameter is only available when the "Control function" parameter is set on
"Cooling," "Cooling with additional stage," "Heating and cooling" or "Heating and
cooling with additional stages".

8.18.98 Setpoint adjustment - Step size of manual setpoint adjustment

Options:
This parameter is used to specify the step size for manual setpoint adjustment.
Product manual 2CKA001473B5472
Control elements and application parameter
Setting option between 0 - 9
Setting option between 0 - 9
Setting option between 0 - 9
0.1°C
0.2°C
0.5°C
1.0°C
Application "Internal RTC"
│205