Commissioning Of The Knx Function Via Dca; Integration Into The Knx System (Ets); Prerequisites - Busch-Jaeger SD/U12.55.11-825 Manual

7

Commissioning of the KNX function via DCA

Commissioning the display for KNX TP takes place via the Engineering Tool Software (ETS) in
connection with the respective device control app (DCA).
– BJE Touch DCA for the 4" RoomTouch
– BJE DCA LC-Display for the 2.4" display
7.1

Integration into the KNX system (ETS)

Notice
The device meets KNX guidelines and can be used as product of the KNX
system. Detailed expert knowledge for understanding by means of KNX training
is assumed, especially with regard to the commissioning software ETS.
7.1.1

Prerequisites

DCA version
The minimum requirement is the use of following software with the ETS app:
– BJE Touch DCA for the 4" RoomTouch
– BJE DCA LC-Display for the 2.4" display
ETS version
The minimum requirement is the use of ETS from version 5.7.7.
SD card
The following SD card types are supported:
Type:
Capacity:
File System:
Notice
■
■
■
Product manual 2CKA001473B5472
Commissioning of the KNX function via DCA
Micro SD
4 - 128 GB
exFAT / FAT32
It is recommended to use SD cards from ScanDisk, Kingston and Transcend
that have been fully tested and checked.
Busch-Jaeger is not liable for the performance of an SD card.
The SD card is not included in the scope of delivery.
®
or the 4" display
® or the 4" display
│36