Configuration Of Applications And Application; Application "Information Page; Application "Input - Busch-Jaeger SD/U12.55.11-825 Manual

7.10 Configuration of applications and application pages
The display can contain applications with specified functions (e.g. scene actuator). When these
applications are activated, they can be accessed via the application pages or the application
runs in the background. You can appropriately configure these applications beforehand.
Notice
Basic settings for the display,see chapter 7.6 "Configuration of system settings
of the display" on page 43 .
7.10.1

Application "Information page"

This application has an information page via which the following messages can be activated
and configured:
The general settings can be made via the DCA.
1. Open the "Information page" tab in the library area.
2. Activate/deactivate the desired messages.
– In the "Parameters" area, the general settings for this application are displayed. They
can be edited here.
For further setting/selection options via the "Parameter" area for setting the information page,
see chapter 8.15 "Application "Internal RTC"" on page 149.
7.10.2

Application "Input"

This application has an information page for selecting and configuring the following inputs:
– Binary input
– Temperature sensor input
The general settings can be made via the DCA.
1. Open the "Input" tab in the library area.
2. Activate/deactivate the desired inputs.
– In the "Parameters" area, the general settings for this application are displayed. They
can be edited here.
For further settings/selections via the "Parameter" area for setting the inputs, see chapter 8.14
"Application "Inputs" " on page 141.
Product manual 2CKA001473B5472
Commissioning of the KNX function via DCA
│65