Busch-Jaeger SD/U12.55.11-825 Manual page 145

Value 1
■
Options:
This parameter is used to select the RTC operating mode for value 1.
Value 2
■
Options:
This parameter is used to select the RTC operating mode for value 2.
Notice
The parameter is only available when the setting "As binary input" is used during
the parameterization of binary input under "Use binary input".
Product manual 2CKA001473B5472
Control elements and application parameter
Auto
Comfort
Standby
ECO
Frost/heat protection
Notice
– The parameter is only available if the "Object type" parameter is set on
"RTC operating mode [1-byte]".
– The parameter is only available if the "Response to pressing" or
"Response to releasing" parameter is set on "Value 1" or on
"Alternating value 1/value 2".
Auto
Comfort
Standby
ECO
Frost/heat protection
Notice
– The parameter is only available if the "Object type" parameter is set on
"RTC operating mode [1-byte]".
– The parameter is only available if the "Response to pressing" or
"Response to releasing" parameter is set on "Value 2" or on
"Alternating value 1/value 2".
Application "Inputs"
│145