System Settings - Commissioning - Busch-Jaeger SD/U12.55.11-825 Manual

10.5.6

System settings - Commissioning

All KNX settings for the device are made via the commissioning tool DCA, which is part of the
special ETS app, See "Inserting the micro SD card (SDHC)" on page 260. The transmission of
the ETS data is made via the KNX interface.
Commissioning
Programming is only possible when the programming mode has be activated beforehand.
Programming mode serves for assigning a physical address that is required for programming
via the ETS.
Fig. 36: Commissioning
1. Change to the "Commissioning" menu.
2. Activate the checkbox "Activate programming mode".
Wall type
The wall-type can be specified by swiping to the right in which display is installed. The options
"Solid wall" and "Hollow wall" are available.
Reboot
Tap on reboot to restart the display.
Reset
Tap on reset for resetting.
Product manual 2CKA001473B5472
Operation
│268