Setpoint Settings - Send Current Setpoint; Setpoint Settings - Cyclic Sending Of The Current Setpoint; Setpoint Settings - Basic Set Value Is; Setpoint Adjustment - Busch-Jaeger SD/U12.55.11-825 Manual

8.18.90 Setpoint settings — Send current setpoint
Options:
The current setpoint value can be sent to the bus either cyclically and after a change, or only
after a change.

8.18.91 Setpoint settings - Cyclic sending of the current setpoint

Options:
This parameter is used to specify the amount of time that will elapse before the current setpoint
is automatically transmitted.
Notice
This parameter is only available when the "Send current setpoint" is set on
"Cyclic and during change".

8.18.92 Setpoint settings - Basic set value is

Options:
Setpoint for cooling comfort:
■
– The device uses the temperature value that has been set via parameter "Setpoint
temperature for cooling comfort" (°C).
Setpoint for heating comfort:
■
– The device uses the temperature value that has been set via parameter "Setpoint
temperature for heating comfort" (°C).
Mean value between heating comfort and cooling comfort:
■
– The device uses the mean value of the two specified setpoints.
The RTC requires a defined basic set value for its function. The parameter is used to specify the
setpoint the device accesses.
Notice
The parameter can only be set when the "Setpoint heating comfort = Setpoint
cooling comfort" parameter is deactivated.

8.18.93 Setpoint adjustment

8.18.94 Setpoint adjustment — Maximum manual increase during heating mode (0 - 9°C)
Options:
Product manual 2CKA001473B5472
Control elements and application parameter
Cyclic and during change
Only for change
00:05:00 - 18:12:15
Comfort cooling setpoint
Comfort heating setpoint
Mean value between comfort heating and cooling
Setting option between 0 - 9
Application "Internal RTC"
│204