Time Programs - Busch-Jaeger SD/U12.55.11-825 Manual

10.3.4

Time programs

Time programs can be used to call up functions according to the time automatically. This, for
example, allows the holiday function to be started and set up.
The time programs application is called up as follows:
1. Tap on the clock icon at the bottom on the main operating page (homepage).
– The overview of the time program opens.
Fig. 27: Overview of the time program
Creating individual timers
1. Tap on the clock icon.
2. Change to the "Timer" view.
3. Select a control element in the pre-selection by tapping.
4. Tap on "Add new timer".
5. Specify the function of the control element.
6. Then, select the start time, the end time and the affected weekdays.
7. If necessary, enable the Astro function.
– This function can be used, for example, to automatically raise or lower the blinds a few
minutes earlier or later depending on the time of year.
– The disabling function "Not before" and "Not after" fixes disabling times before or after
which no functions are carried out. For this the time can also be set via the scrolling
element.
8. Tap on the blue tick at the bottom right to confirm the settings.
– The time program is then taken up into the time program list and can there be activated
and deactivated by actuating the blue slider.
Notice
The available settings depend on the control element that is integrated in the
time program. This, for example, also allows the setting of colour ranges for
RGB lamps and corresponding values and steps for dimmers and fans.
Deleting timer
1. Change to the "Timer" view.
2. Select a timer.
3. Swipe to the left.
– A dustbin icon is displayed and the timer is deleted.
Product manual 2CKA001473B5472
Operation
│258