Advertisement
Loosen the cap screws (item 10), take off
and remove the holding fixture "S" from
the housing.
Pressing-off by means of 2nd hand pump
Alternatively the wheel shaft can be
pressed off with a second press-out
cylinder, e.g. in the mobile area. It is to be
proceeded as follows:
Connect the dis- and assembly fixture
with the press-out cylinder for the wheel
shaft and bolt it with the transmission
completely.
(S) Press-out cylinder 63428
Actuate the pressure oil device (item 7)
until approx. 30MPa/4300psi is reached.
Under this pressure the bevel gear is
expanded sufficiently.
This pressure is to be kept constant by
pumping subsequently until the wheel
shaft has been loosened completely.
Actuate the second oil pressure device
(item 8) until the pressure oil cylinder has
loosened the wheel shaft from the bevel
gear completely.
3-16
BRJ7DU069
BRJ7DU070
BRJ7DU071
BRJ7DU072
Advertisement
