Advertisement
(5)
Determination of seat
The seat must be 10 to 15 mm.
Measure Dimension A from plane
face/wheel shaft to face/crown gear once
again (see chapter 9) (3) at page 3-38
"Determination of control dimension for
seat").
Dimension "A" e.g. 44.34 mm
Example:
Dimension "A" after pressing-on 44.43
mm
Dimension "A" after pressing-on 30.85
mm
Resulting difference = Seat 13.49 mm
If the seat determined is not between
10 and 15 mm a new wheel shaft and
a new crown gear have to be installed.
Install the retaining ring (item 2).
3-41
BRJ7DU140
BRJ7DU141
Advertisement
