Advertisement
(4)
Loosening of taper press fit
For work at high oil pressures to loosen the taper press fit there is the danger of eye and
skin injuries, if oil would come out under high pressure. Always wear goggles and safety
gloves! Observe and follow the instructions of the pressure oil device manufacturer.
A pressure oil device with a maximum
pressure of up to 300 MPa is necessary
for widening of the taper press fit. There
are two possibilities to press out the shaft
wheel from the crown gear which are
described in the following:
(S) Pressure oil device 62222
Pressing-off by means of press
Locate the housing (item 1) in the press-
out fixture "S" on the press as shown in
the picture.
(S) Press-out fixture 63428
The holding fixture "S" which is used as
stop for the gliding off wheel shaft is to be
connected to the cover surface with the
appropriate cap screws (item 2).
Fasten the 4 supporting bolts (item 3)
hand-tight until contact with the crown
gear.
(S) Holding fixture 62519
3-14
BRJ7DU062
BRJ7DU063
BRJ7DU064
Advertisement
