Advertisement
9)
INSTALLATION OF CROWN GEAR AND WHEEL SHAFT INTO THE HOUSING
(1)
Installation of thread protective shield
and radial sealing ring
Wet the thread protective shield (item1)
on the bore seat evenly with LOCTITE
270 and install it until contact by means
of the striking mandrel "S".
(S) Striking mandrel
Apply a thin and even layer of LOCTITE
574 onto the outer diameter of the radial
sealing ring.
By means of the striking mandrel "S"
drive the radial sealing ring (item 2) into
the housing seat until contact is obtained
at the mandrel.
(S) Striking mandrel
Pay attention that the radial sealing
ring is not jammed during installation.
Jamming will cause leakage.
Do not damage the sealing lip of the
radial sealing ring.
Wet the sealing lip of the radial sealing
ring with grease (e.g. Shell Alvania R3)
slightly.
63293
63291
3-37
BRJ7DU129
BRJ7DU130
BRJ7DU131
Advertisement
