Advertisement
(
(
3)
Turtle
The turtle symbol (3) is normally off; when it appears (fixed) it shows activation of the "soft" mode
of the truck, in which maximum speed and acceleration are reduced. The "soft" mode can be
activated pressing button
(4)
Hour meter
The number displayed on the bottom right side of the unit (4) shows the Hours Worked.
The letter present near the hour meter shows which hour meter is displayed:
- K : the key hour meter is displayed;
- T : the traction hour meter is displayed;
- P : the pump hour meter is displayed; it increases if pump control is working.
(5)
Accelerator
The accelerator level indication is displayed on the central top side of the unit (5); it is shown by
ten notches. When the accelerator level is minimum only a notch is displayed, when the
accelerator level is maximum all the ten notches are displayed. Each notch represents 1/10 of the
difference between maximum and minimum accelerator level.
(6)
Speed
The number displayed under the accelerator notches on the center of the unit (6) shows the truck
speed. The unit can be km/h or mph depending on the SPEED UNIT parameter setting.
(7)
Wheel position
The notch displayed on the left of the hour meter (7) represents the wheel (only one of the nine
notches is displayed) and shows the steering angle (it corresponds to the relative truck direction if
the truck is running).
(8)
Running direction
Angle 180
(Default setting)
The arrow (8) shows the set truck rulling direction. The arrow point is up to when the truck is
forward running; the arrow point is down when the truck is reverse running. If the truck doesn't run
a dot is displayed instead of the arrow.
Angle 360 (Selectable setting at parameter change menu of EPS controller)
If you select this function(please see the 7-51), you can steer to every direction.
When the wheel position is over 180 , the direction and wheel position display is reversed like
below.
.
7-54
Advertisement
