Advertisement
7)
INSTALLATION OF BEARING FOR BEVEL PINION SHAFT AND EXACT SETTING OF THE
BEARING PRELOAD
(1)
Preassembly of bevel pinion shaft with bearing
Use a hand-lever press for pressing the
taper roller bearing inner ring (item 1)
with the press-in sleeve "S" cautiously on
the bevel pinion shaft (item 2) until
contact is obtained.
Pay attention to the gearing when the
bearing of the bevel pinion shaft is
installed. In case of damage, noise
problems can be caused later.
(S) Press-in sleeve 223705.22
(2)
Installation of bearing outer ring into the
housing
Prepare the shim thickness determined
according to chapter (1) at page 3-26
"Determination of the necessary shim
thickness for the exact installation
dimension setting of the bevel pinion
shaft" by means of the differently thick
shims.
Put the shim(s) (item 1) and the bearing
outer ring (item 2) into the bearing seat.
By means of striking mandrel "S" install
the shim (s) and the bearing outer ring
into the bearing seat of the housing until
contact is obtained.
A repeated measurement of the
bearing height is only allowed to result
in a deviation of max. 0.05 mm.
Otherwise the process of the shim
calculation has to be repeated.
(S) Striking mandrel 62529
3-29
BRJ7DU102
BRJ7DU103
BRJ7DU104
Advertisement
