Advertisement
(3)
F
F
low chart showing how to use the TESTER function of the digital console:
Opening Zapi menu.
Press ENTER to go into the MAIN MENU.
The display will show: PARAMETER CHANGE.
Press ROLL UP or ROLL DOWN until TESTER
menu appears on the display.
The display will show: TESTER.
Press ENTER to go into the TESTER function.
The first variable to be tested is shown on the
display.
Press either ROLL UP or ROLL DOWN buttons.
Next variable for measurement appears.
When you have finished press OUT.
The Display will show: TESTER.
Press OUT again and return to opening Zapi
menu.
Remember it is not possible to make any changes using TESTER.
All you can do is measure as if you were using a pre-connected multimeter.
7-59
20B7EL30
Advertisement
