Hyundai 10BOP-7 Operation Manual page 71

6) DETERMINATION OF BASIC INSTALLATION DIMENSIONS
(1) Determination of the necessary shim thickness for the exact installation dimension setting of
the bevel pinion shaft
The correct position of the bevel pinion shaft is required for an optimum service life of the
transmission.
Thickness of the shim (Item 1) and the correct setting of the bevel pinion shaft respectively will be
determined according to the following method:
Put measuring fixture I Part
(see figure 95) into the housing
bearing bore L1 until contact is
obtained.
Put measuring fixture I Part
(see figure 96) into the housing
bearing bore L2 until contact is
obtained and fasten it hand-
tight with measuring fixture I
Part .
Put measuring fixture part
zero.
(S) Measuring fixture I 62231
to
3-25
BRJ7DU094