Advertisement
GROUP 3 DISASSEMBLY AND ASSEMBLY
1.
INSTRUCTION
1)
Pay attention to cleanliness and expert like manner for all work to be carried out. Transmission
removed from the vehicle has therefore to be cleaned prior to opening. Both utmost care and
cleanliness are essential conditions for a correct disassembly and reassembly of the transmission
as well as for the installation of each spare part. A fault during installation can result in an early wear
and chips or other foreign particles in the transmission can cause fatal damages.
2)
Prior to assembly all parts must be cleaned and inspected for wear and other defects.
3)
If it is found that removed parts are damaged or worn, do not reinstall but replace them by new
ones.
4)
If not separately indicated, the housing and cover faces forming an oil tight connection are to be
provided with the corresponding sealing compound during assembly.
5)
Special devices and special tools are necessary besides the standard tools. Their use is
unavoidable for a technically adequate dis- and reassembly. The application of devices, special
tools and other fixtures are to be adapted to circumstances of the respective users.
6)
Commercial tools and fixtures belonging to the basic equipment are assumed to be available.
7)
If not otherwise indicated all pressing operations are made by means of the hand lever press.
8)
All screws and threads in this transmission have metric dimensions. Only spanners and socket
spanners with metric sizes are allowed to be used.
9)
For reassembly all of the indicated setting values, test data and tightening torques must be
observed.
10)
Observe the described sequence of the working steps.
11)
All pictures serve the illustration and are not obliging for this execution.
3-5
Advertisement
