Advertisement
Description
Set option
This option (on/off) is used to launch the autoteaching procedure. Take care there is
not mechanical angle limitation before to turn it on. Then recycle the key and the
steering motor starts an automatic sequence to collect the ENC COUNT AT 360
and ENC COUNT AT 180. If the collected couple is consistent ( ENC COUNT AT
180 stays inside the window from 3/8 to 6/8 of ENC COUNT AT 360) they are
automatically saved on the settings SET ENC AT 360 and SET ENC AT 180. If the
AUTOTEACHING
autoteaching procedure successful ends, the display switches from the DATA
ACQUISITION alarm to the collected values (in the range 0 to 5Vdc. Left side shows
the ENC COUNT AT 360 value; the right side shows the ENC COUNT AT 180
value).
If the couple of values is not consistent they were not saved and the display
switches cyclically from the collected data to the DATA ACQUISITION inscription.
7-44
Advertisement
