Advertisement
GROUP 2 REMOVAL AND INSTALLATION OF UNIT
Remove and install following units as explained in the flow chart.
1. MAST
REMOVAL
1)
Fork
(1)
PREPARATION
Lift up the platform from the floor to easy
removal of the forks.
Prop up blocks under the platform in
order that it can avoid from unintentional
lowering of the platform.
When propping up the block under the
platform, pay careful attention to
support it properly so that they can
prevent the platform from dropping on
the floor.
It can cause to happen unexpected
accident such as personal injury or
death.
Turn the start switch off and then
disconnect the battery connector from the
order picker truck.
Disconnect harnesses.
Platform &
Mast
overhead guard
2-2
Piping
PUMP
INVERTER
Battery cable
connector
TRACTION
INVERTER
LINE
CONTACTOR
Harness connector
Harness connector
10BOP7RE01
10BOP7OM121
10BOP7RE04
Advertisement
