Advertisement
(6)
Removal of thread protective shield and
radial sealing ring
By means of a hammer remove the
thread protective shield (item 1) from the
glued joint on the housing.
Do not damage the housing and
supporting face!
With a screwdriver and a hammer expel
and remove the radial sealing ring (item
2) cautiously from the housing seat.
Do not damage the surface where the
radial sealing ring is seated! At this
working step the radial sealing ring is
destroyed completely.
(7)
Disassembly of bearings
Disassembly bearings drive pinion
With an extracting fixture (S) pull out the
grooved ball bearing (item 1) from the
bore of the housing seat and dispose it of
acc. to chapter 6.
The service of the extracting fixture (S) is
analogous like in the figures 47 to 51
shown.
(S) Extracting fixture 225296
Upon removal of the bearing outer
rings put them to the respective
bearing inner ring.
3-20
BRJ7DU085
BRJ7DU086
BRJ7DU087
Advertisement
