Advertisement
Place counter holder "N" into the
assembly fixture and preload it hand-tight
against the wheel shaft (cf. figure 124).
(N) Counter holder 62507-1
Mount the taper roller bearing inner ring
(item 2) by means of striking mandrel "S"
onto the bearing seat of the wheel shaft
(item 3) until contact is obtained.
(S) Striking mandrel
(4)
Installation of housing cover
Use a new O-ring for the installation. Wet the O-ring with transmission oil or grease slightly.
Clean plane face of the housing cover carefully and do not damage it.
Put the o-ring (item 4) into the groove of
the housing cover.
Plane face for housing cover on the
housing is to be cleaned carefully and
must be grease-free.
Apply a thin and even layer of LOCTITE
574 onto the plane face.
Place the housing cover cautiously and
install it slightly tapping with a dead-blow
soft face hammer until contact is
obtained.
By means of cap screws M10 25 (item
5) bolt the cover to the housing. Tighten
the cap screws crosswise evenly!
Tightening torque of the cap screws : 46 Nm.
63294
3-44
BRJ7DU146
BRJ7DU147
BRJ7DU148
BRJ7DU149
Advertisement
