Advertisement
5. COMPLETE REASSEMBLY
1)
GENERAL INSTRUCTIONS FOR REASSEMBLY
(1)
Clean components by means of cleaning agent if necessary and remove the loctite residues.
(2)
Check all components for wear, damage and cracks, if necessary components have to be
replaced.
(3)
All connection faces and plan face clean and steadily smoothing.
2)
CONSUMABLES
Suitable cold cleaners, e.g. LOCTITE.
Only use suitable agents, which are non toxic, non-combustible and permissible on the market.
Never use benzens, solvents or other combustible agents for cleaning purposes.
Description
Loctite No. 243
Loctite No. 270
Loctite No. 574
Loctite No. 5910
Grease "Shell Alvania R3"
Siilicone grease 704 or transmission oil
acc. to API GL-5 or MIL-L-2105C/D
3)
USED DESCRIPTIONS AND SYMBOLS
You will find again all descriptions used in the following sections and their calculations.
Description
Bearing width taper roller bearing
Housing dimension
Housing bearing bore 1
Housing bearing bore 2
Housing bearing bore 3
Zero position at measuring fixture
I(Part I) with dial gauge
Difference dimension bevel pinion
shaft calculation of L3
Zero position at measuring fixture
II(Part I) with dial gauge
Difference dimension crown gear
calculation of L3
Installation dimension bevel pinion
shaft
Bearing difference dimension
Constant
Constant
Free constant
Shim dimension
Bush width
Shim thickness
Screw lock up to size M10 and bigger
Screw lock for studs
To glue the shaft seals into the housing & sealing of housing and cover
Surface sealing for side cover on the housing
To grease or wet the sealing lip of the shaft seal
To grease or wet the O-rings
Dimension "B"
Dimension "G"
L1
L2
L3
Dimension "1"
Dimension "2"
Dimension "3"
Dimension "4"
Dimension "E"
Dimension "D"
K1
K2
a
Dimension "P"
Dimension "H"
Dimension "X"
3-22
To be used for
Symbol
Advertisement
