Advertisement
Install the bevel pinion with space bush
(item3) from the bottom into the housing
and assemble is through the profiled seat
of the helical gear bore.
Preload the bevel pinion shaft (item 3)
with the counter holder "S" hand-tight
against the bearing outer rings in the
housing.
(S) Counter holder 62507-1
By means of striking mandrel "S" install
the helical gear until contact is obtained.
Hand-tighten the adjusting screw on the
counter holder repeatedly, so that all
components like taper roller bearing,
spacer bush and shims are located
exactly.
When all components are located tightly
the counter holder can be removed
again.
(S) Striking mandrel 62846
Insert gear lock "S" into the housing
bearing bore of the drive pinion and block
the helical gear.
(S) Gear lock 62228
3-35
BRJ7DU123
BRJ7DU124
BRJ7DU125
BRJ7DU126
Advertisement
