Advertisement
Snap the retaining ring (item 2) by means
of flat-head pliers into the groove of the
housing bore and install it until contact is
obtained.
Wet the sealing lip of the radial sealing
ring with grease (e.g. Shell Alvania R3)
slightly.
Apply a thin and even layer of LOCTITE
574 onto the outer diameter of the radial
sealing ring.
By means of striking mandrel "S" drive
the radial sealing ring with the closed
surface upwards into the housing seat
until contact at the mandrel is obtained.
(S) Striking mandrel
(4)
I
I
nstallation of sealing cap
Press the breather valve (item 1) slightly
by hand into the central bore of the
sealing cap (item 2) (Reference depth
approx. 5mm).
Insert the sealing cap with breather valve
(item 3) into the boring seat of the
housing bore in the bevel pinion shaft.
By means of the striking mandrel "S"
install the sealing cap subsequently until
contact is obtained.
(S) Striking mandrel
62521
62522
3-49
BRJ7DU162
BRJ7DU163
BRJ7DU164
BRJ7DU165
Advertisement
