Advertisement
Charger TRIP is occurred after it started charging and charging completion lamp is on.
(In case input voltage is normal - Refer to the error detection No. 1)
Restore the charger as pushing reset switch.
Measure
the output current by
DC current measure
Is it normal?
YES
Change PCB or
Request After-Service
After separating battery connector,
NO
put the automatic/manual selection
switch to manual
Change
SCR Module
7-114
Measure the output
NO
Check
SCR Module
Is it ok?
NO
YES
Change
PCB
voltage 64V
YES
Contact fault between
the battery connector
and charger connector
Battery is over-
discharged
Advertisement
