Advertisement
Maintenance
The options are :
PRESENT : A maintenance hour-counter is incremented with key ON.
When the hours elapsed reach the programmed value with the display the warning
SERVICE REQUIRED is shown.
ABSENT : No SERVICE REQUIRED warning
M
M
aintenance done
It can be ON/OFF. This parameter is normally off. Setting the MAINT. DONE on at next key-on
the maintenance hours are updated with the display s hour meter contents. This operation erases
the MAINTENANCE NEEDED warning if it is present.
S
S
eat belt status
It sets the Seat belt diagnostic LED indication in the following way:
OPTION #1 : No Seat belt indication. The diagnostic LED is not used.
OPTION #2 : If the seat belt are not fastened at Key-ON the diagnostic LED blinks for three times
than it turns off.
OPTION #3 : The diagnostic LED blinks until the seat belt is fastened than it turns off.
(
(
3)
S
S
ubmenu "ADJUSTMENTS"
Delay display OFF
This parameter sets the display ON Service time . If the CNB#4 is connected to +batt after key-
off the display is still supplied for a programmable time, follow the table below to choose your
temporization :
Delay display
off level
Service time
[sec]
0
1
2
1
3
5
3
4
5
7
9
11
7-56
6
7
8
13
15
17
9
20
Advertisement
