Advertisement
Put the bearing inner ring (item 3) into the
outer ring of the taper roller bearing.
(1)
Installation of grooved ball bearing for
drive pinion
Install the grooved ball bearing (item 1)
with the striking mandrel "S" into the
bearing seat of the housing until contact
is obtained.
(S) Striking mandrel 62625
Prior to installation of the helical gear
the lower grooved ball bearing has to
be installed into the housing bearing
bore.
(2)
Installation of helical gear with bevel
pinion shaft
Apply a thin and even layer of LOCTITE
270 onto the internal gearing of the
helical gear (item 1).
Wear safety gloves for working with
adhesives and observe the LOCTITE
instructions.
Insert the helical gear (item 2) by the
lateral opening of the housing, align it
centrally and put it onto the taper roller
bearing.
When inserting the helical gear pay
attention that the helical gear is not
damaged. In case of damage noise
problems can occur later.
3-34
BRJ7DU116
BRJ7DU120
BRJ7DU121
BRJ7DU122
Advertisement
