Advertisement
4)
USE OF REMOVED SHIMS AS BASIS FOR REASSEMBLY
The bevel gear set, consisting of bevel pinion shaft and crown gear, has fixed installation
dimensions. However the transmission housing and the taper roller bearings have to be measured.
(1)
If the removed shims are used as basis it is not necessary to measure the transmission housing.
(2)
If all of the removed components are to be reused, the original shim thickness has also to be used
again.
(3)
If the taper roller bearings with the bevel gear set replaced, only the taper roller bearings have to
be measured.
3-23
Advertisement
