Module Parameter Setting - Mitsubishi Electric CC-Link IE TSN User Manual

6.3

Module Parameter Setting

Set the module parameters of the NZ2GN-GFB from the "CC-Link IE TSN Configuration" window of the engineering tool.
The following methods are available for to set the parameters of the NZ2GN-GFB.
• Parameter Automatic Setting ( Page 57 Parameter automatic setting)
• Parameter Processing of Device Station ( Page 62 Device station parameter processing)
The configured parameters are applied at the next startup.
• The module parameters of the NZ2GN-GFB cannot be set from the CC-Link IE Field Network master
station.
• The module parameters cannot be changed when the module is running. An error (error code: 02A0H)
occurs when they are changed. Power off and on the NZ2GN-GFB or reset it. ( Page 56 Resetting the
NZ2GN-GFB)
The following clears the NZ2GN-GFB errors.
• Parameters were written to the NZ2GN-GFB during device station parameter processing.
• A parameter different from the configured parameter is written due to parameter automatic setting.
Parameter save destination
The following table shows the parameter save destination for each method.
Item
Parameter Automatic Setting
Parameter Processing of Device Station
Behavior of the NZ2GN-GFB
The following shows the operation of the NZ2GN-GFB related to parameters.
• When parameter automatic setting is used during NZ2GN-GFB data link, the parameters set by parameter automatic
setting are saved in the non-volatile memory in the NZ2GN-GFB.
• When device station parameter processing is executed after NZ2GN-GFB data link, the parameters are saved in the non-
volatile memory in the NZ2GN-GFB.
When setting parameters using device station parameter processing, do not perform parameter automatic
setting.
When device station parameter processing is executed after performing parameter automatic setting, the
parameters in the non-volatile memory in the NZ2GN-GFB are changed into the parameters set using device
station parameter processing. However, when the NZ2GN-GFB is turned off or disconnected and data link is
executed again after that, the parameters in the non-volatile memory in the NZ2GN-GFB are overwritten by
the parameters set using parameter automatic setting.
Description
• CPU module of CC-Link IE TSN master station (CPU built-in memory or SD memory
card)
• NZ2GN-GFB
NZ2GN-GFB
6 PARAMETER SETTINGS
6.3 Module Parameter Setting
6
47