Setting For Connection Between The Ethernet Adapter Module And A Got - Mitsubishi Electric NZ2GF-ETB User Manual

7.4.1
Setting for connection between the Ethernet adapter module
and a GOT
The Ethernet adapter module can be connected to a GOT by "Ethernet connection".
(1) Setting for the Ethernet adapter module
Set the third and forth octets of the IP address within the following ranges.
(2) Setting on the GOT
(a) Access from the GOT to the Ethernet adapter module
Configure the same settings for the GOT as those for "Ethernet connection" of the QJ71E71, except for the
following two items.
• Set "MELSEC-L" for "Type" in "Controller Setting."
• Set the following values for the network and station numbers of the connected Ethernet adapter module.
Network No.: The third octet value of the Ethernet adapter module's IP address
• Station No.: The fourth octet value of the Ethernet adapter module's IP address
The IP address of the connected Ethernet adapter module is 192.168.3.30.
Ex.
192. 168. 3. 30
192. 168. 3. 30
CHAPTER 7 COMMUNICATION OF THE ETHERNET ADAPTER MODULE
Set a value within the range of 1 to 64.
Set a value within the range of 1 to 239.
Set 30 for the station number.
Set 3 for the network number.
7
131