Installation Environment And Installation Position; Installation Environment - Mitsubishi Electric CC-Link IE TSN User Manual

5.2

Installation Environment and Installation Position

Installation environment

Installation location
Do not install the NZ2GN-GFB in the following environment:
• Ambient temperature is outside the range from 0 to 55;
• Ambient humidity is outside the range from 5 to 95% RH;
• Condensation occurs due to rapid temperature change;
• Corrosive gas or combustible gas is present;
• Conductive powder such as dust and iron powder, oil mist, salinity, or organic solvent is filled;
• The I/O module is exposed to direct sunlight;
• A strong electric field or strong magnetic field is generated; and
• The I/O module is subject to vibration and shock.
Installation surface
Install the NZ2GN-GFB on a flat surface. If the mounting surface is uneven, excessive force will be applied to the printed-
circuit board, possibly causing failure.
• Do not put oil on the screws used to install or set up wires for the NZ2GN-GFB. Failure to do so may
damage the screw.
• Tighten the screws with an applicable screwdriver. Tightening with an inapplicable screwdriver may damage
the screws.
5 INSTALLATION AND WIRING
30
5.2 Installation Environment and Installation Position