Mitsubishi Electric CC-Link IE TSN User Manual page 53

Basic settings (CC-Link IE Field Network)
Item
CC-Link IE Field Station No.
Network device station
setting
Station type
*4
32nd station
RX/RY points
RWw/RWr points
Reserved/Error
invalid station
*3 If a parameter is not set, the module will operate using the default value.
*4 The number of device stations set in "Total number of device stations" is reflected in the module parameters of the NZ2GN-GFB.
Any value that exceeds the number of stations set in "Total number of device stations" is ignored.
*5 If the total number of "RX/RY points" and "RWw/RWr points" that were set exceeds the maximum number of link points (1 network) of
CC-Link IE Field Network, an error (error code: 0292H or 0293H) occurs and all parameters are not saved in the non-volatile memory of
the NZ2GN-GFB. Set it again after correcting the value. ( Page 16 Performance Specifications)
*6 If the CC-Link IE TSN Class setting is set to A, set the values so that the total number of "RX/RY points" and "RWw/RWr points" does not
exceed 2048 bytes. ( Page 93 CC-Link IE TSN Class setting function)
Application settings (CC-Link IE Field Network)
Item
Communication Mode
Event Reception From Other Stations
*7 If a parameter is not set, the module will operate using the default value.
Setting
Same as 1st station
*5*6
*5*6
Setting
Sets the communication mode of CC-Link IE Field Network of the NZ2GN-
GFB.
For details on the normal mode and high-speed mode, refer to the following.
Page 272 Differences in Cyclic Transmission Modes
Sets whether to acquire events that occur in other stations of CC-Link IE Field
Network.
*3
Setting range
1 to 120
(Default: 32)
Same as 1st station
*7
Setting range
• 0: Normal
• 1: High-Speed
(Default: 0: Normal)
• 0: Disable
• 1: Enable
(Default: 1: Enable)
6 PARAMETER SETTINGS
6.3 Module Parameter Setting
6
51