Mitsubishi Electric CC-Link IE TSN User Manual page 224

Parameter area initialization completed
■Address
Item
Parameter area initialization completed
■Description
This command is turned on once parameters saved in the non-volatile memory in the NZ2GN-GFB are set as default values
using 'Parameter area initialization command' (1002H).
■Setting value
b15 b14 b13
*1
Fixed to 0
*1 A value set in bit 1 to bit 15 is ignored.
• On: Initialization completed
• Off: Not implemented yet
For operation of the parameter clear, refer to the following.
Page 221 Parameter area initialization command
APPX
222
Appendix 3 Remote Buffer Memory
b12 b11 b10 b9
Address
1003H
b8 b7 b6 b5 b4 b3 b2 b1 b0
Setting
value