Function Setting Switch Setting - Mitsubishi Electric CC-Link IE TSN User Manual

Function setting switch setting

Set the following functions using the function setting switch on the front of the NZ2GN-GFB.
• Unit test
• CC-Link IE TSN Class setting function
• Communication speed setting function
The setting of function setting switch is enabled when the NZ2GN-GFB is powered on, so set each function when the module
is powered off.
When operating the function setting switch, use a flathead screwdriver having a blade of 1.2mm or less in
width.
Setting method
Set each function with function setting switch 1 to function setting switch 4.
Switch name
Function setting switch 1 TEST
Function setting switch 2 MODE
Function setting switch 3 LINK SPEED

Function setting switch 4
Do not change any function setting switch while the NZ2GN-GFB is powered on. Doing so causes an error
(error code: 0202H to 0205H) to occur and the changes are not applied. Returning the function setting switch
to its previous position and turning on 'Error clear request flag' (RWw0.b10) eliminate the error.
Precautions
Slide one function setting switch at a time horizontally. Do not hold the screwdriver at an angle or pivot it off the edge of the
case while working a function setting switch, since damage or deformation may result.
(1) Flathead screwdriver
(2) Function setting switch
Function name
Unit test
CC-Link IE TSN Class setting function
Communication speed setting
function
Use prohibited
(1)
(2)
Setting
Turn it off during normal operation.
Turn it on when performing unit tests. ( Page 144 Unit Test)
Sets CC-Link IE TSN Class. ( Page 93 CC-Link IE TSN Class
setting function)
Set the communication speed. ( Page 92 Communication speed
setting function)
Fix these switches to off.
5 INSTALLATION AND WIRING
5
29
5.1 Setting Switch