Chapter 10 Troubleshooting; Cc-Link Ie Tsn/Cc-Link Ie Field Diagnostics; Cc-Link Ie Tsn Diagnostics - Mitsubishi Electric CC-Link IE TSN User Manual

10
TROUBLESHOOTING
This chapter describes error contents that may occur while the NZ2GN-GFB is used and troubleshooting for those errors.
10.1

CC-Link IE TSN/CC-Link IE Field Diagnostics

Status monitoring, operation tests, or other diagnostics are performed for CC-Link IE TSN and CC-Link IE Field Network.

CC-Link IE TSN diagnostics

CC-Link IE TSN can be diagnosed using the engineering tool connected to the CPU module of the CC-Link IE TSN master
station and local station.
For details on the diagnostic window, refer to the user's manual for the CC-Link IE TSN master station used.
Remote reset
Perform the following steps to remotely reset a selected NZ2GN-GFB.
1.
Select the device station to be reset and click the [Remote Operation] button.
2.
Follow the on-screen instructions and click the [Yes] button.
3.
Follow the on-screen instructions and click the [OK] button.
• The remote reset of the NZ2GN-GFB affects communications on other stations so it may cause other
stations to disconnect.
• When remote reset is performed, if the setting of either function setting switch 1 or 3 is different from the
setting during module power-on, an error (error code: 0270H) occurs, and the NZ2GN-GFB is not reset
remotely.
• Remote reset can also be done from the "Command Execution of Device Station" window. ( Page 56
Resetting the NZ2GN-GFB)
10 TROUBLESHOOTING
10.1 CC-Link IE TSN/CC-Link IE Field Diagnostics
10
119