Mitsubishi Electric CC-Link IE TSN User Manual page 214

Valid number of "CC-Link IE TSN station No. <-> IP address conversion setting"
■Address
Item
Valid number of "CC-Link IE TSN station No. <-> IP address conversion
setting"
■Description
This address is used to set the number of CC-Link IE TSN station No. <-> IP address conversion setting to enable.
The CC-Link IE TSN station No. <-> IP address conversion setting needs to be set when communicating between different
networks with the NZ2GN-GFB as a relay station and the other station on CC-Link IE TSN is a request station, relay station,
or destination station.
For details, refer to the following.
Page 55 CC-Link IE TSN station No. <-> IP address conversion setting
■Setting value
b15 b14 b13
*1
Fixed to 0
*1 A value set in bit 7 to bit 15 is ignored.
• 0000H: Not set
• 0001H to 0078H: 1 to 120 (unit)
To enable a set parameter, refer to the following.
Page 184 Operation condition setting request flag (RWw0.b9)
If a value outside the configurable range is written and the 'Operating condition setting request flag'
(RWw0.b9) is turned on, an error (error code: 028AH) occurs and all parameters are not saved in the non-
volatile memory of the NZ2GN-GFB. Set it again after correcting the value.
APPX
212
Appendix 3 Remote Buffer Memory
b12 b11 b10 b9
Address
0129H
b8 b7 b6 b5
Setting value
b4 b3 b2 b1 b0