Chapter 8 Various Settings; Parameter Setting - Mitsubishi Electric NZ2GF2B1-16D User Manual

CHAPTER 8
This chapter describes the setting procedures of the I/O module.
8.1

Parameter Setting

Set the parameter of this module with the network parameter written to the CPU module of the master station. For the
setting procedure of the master station, refer to the following.
 User's manual for the master/local module used
Remark
● Check "Set the network configuration settings in CC IE Field configuration window" on the "MELSECNET/CC IE/Ethernet
Module Configuration" window in advance.
● To select an extension module in the "CC IE Field Configuration" window, select the following models from the "Module
List" window.
Extension Digital Input Module
Extension Digital Output Module
● When points less than the ones of the main module and extension module are set for the remote I/O signal and remote
register, no error occurs. The cyclic transmission is performed for the data of the points set from the start.
● To select a main module listed below in the "CC IE Field Configuration" window, select the following models from the
"Module List" window.
NZ2GF2B1N-16D
NZ2GF2B1N-16T
NZ2GF2B1N-16TE
160
VARIOUS SETTINGS
Extension module type
Module model name
Name
NZ2EX-16(DI)
NZ2EX-16(DO)
Selection for the "CC IE Field Configuration" window.
NZ2GF2B1-16D
NZ2GF2B1-16T
NZ2GF2B1-16TE