Turning On And Shutting Down The System; Turning On The Dxi6902; Figure 13 Powering On The Dxi6902 Expansion Modules (Ebods) - Quantum DXi6902 Field Service Manual

Turning On and Shutting Down the System

Turning on the DXi6902

Figure 13 Powering on the
DXi6902 Expansion Modules
(EBODs)
Quantum DXi6902 User's Guide
To turn on or shut down the DXi6902, refer to the following sections:
• Turning on the DXi6902
• Turning off the DXi6902
To turn on the system, power on the DXi6902 system components in the
following order:
1 Turn on both power switches on the back of each Expansion module
(EBOD) (see Figure
rear of the module displays 00 (approximately 1 minute).
2 Turn on both power switches on the back of each Array module
(RBOD) (see Figure
rear of the module displays 99 (approximately 3 minutes).
3 Press the power button on the front of the Node (see
Wait for the system to boot before attempting to log on.
Note: The system can take approximately 30 minutes to start up,
depending on the amount of installed storage capacity.
Seven segment display
ID/Diag
Expansion module (rear view)
Chapter 1: DXi6902 Basic Operations
Turning On and Shutting Down the System
13). Wait until the seven segment display on the
14). Wait until the seven segment display on the
Port 1
Figure 15).
Port 1
ID/Diag
Power switches
21