Listing Existing Vtl And Its Attributes; Listing Available Library Models; February - Quantum DXi V-Series Manual

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-09 Rev B

February 2014

Listing Existing VTL and
Its Attributes
Listing Available Library
Models
12
syscli --list vtl [--name <VTL_name>]]
This CLI command allows the CLI admin to display a list of all existing VTLs on
the system and their attributes when no partition name is specified. If a VTL
name is specified, only that VTL is listed with its attributes. The attribute list
includes the name of the VTL, mode, library model, drive model type, number of
drives, number of media, number of slots, serial number, data deduplication
status (enabled/disabled) and backup window status (enabled/disabled). If the
backup window status is enabled, the list will also include the start and end
time of the backup window.
An example output for a VTL named myvtl is shown below:
List of all existing VTL's:
Total count = 1
[vtl = 1]
name = myvtl
mode = offline
model = DXi6700
drivemodel = QUANTUMDLTS4
drives = 2
media = 2
slots = 12
serial = 123456XYZ
dedup = enabled
backupwindow = disabled
syscli --list library
This CLI command allows the CLI admin to display a list of the available library
models. Specific library model or product ID is required when adding or creating
a new partition.
An example output of three supported library models is shown below:
List of all available library models:
Total count = 1
[library = 1]
productid = DL1500
description = EMC Disk Library
[library = 2]
productid = Scalar 100
description = ADIC Scalar 100
[library = 3]
VTL Configuration CLI Commands