Listing Available Library Models; Listing Of Supported Tape Drive - Quantum DXi V1000 Command Manual

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
Listing Available Library
Models
Listing of Supported
Tape Drive
12
slots = 12
serial = 123456XYZ
dedup = enabled
backupwindow = disabled
syscli --list library
This CLI command allows the CLI admin to display a list of the available library
models. Specific library model or product ID is required when adding or creating
a new partition.
An example output of three supported library models is shown below:
List of all available library models:
Total count = 1
[library = 1]
productid = DL1500
description = EMC Disk Library
[library = 2]
productid = Scalar 100
description = ADIC Scalar 100
[library = 3]
productid = Scalar i2000
description = ADIC Scalar i2000
syscli --list drive
This CLI command allows the CLI admin to display a list of the available virtual
tape drive models. A specific virtual tape drive model is required when adding or
creating a new partition.
An example output of two tape drive is shown below:
List of all available drive models:
Total count = 2
[drive = 1]
model = QUANTUMDLTS4
description = Quantum DLT S4
[drive = 2]
model = QUANTUMSDLT320
description = Quantum SDLT 320
VTL Configuration CLI Commands