Access Panel Frame - Christie CP2230 Service Manual

Section 5: Parts and Module Replacement

5.5.10 Access Panel Frame

The Access Panel Frame is located on the operator side (right) near the front of the projector. To access the
components in the cardcage and light engine compartments the access panel frame must first be removed.
(Estimated Replacement Time: 8 minutes)
1. Remove PIB/ICP Cover. (Figure 5-9)
2. Remove the light engine air filter cover (including filter).
(Figure 5-12)
3. Remove the four, #2 Phillips
access panel frame securing it to the chassis.
(Figure 5-10)
4. Tilt the access panel frame a little to the front (lift left
side) to clear the LVPS/LPS cover and remove.
5.5.11 Rear Top Lid
The rear top lid can be rotated around the exhaust opening. To remove the rear top lid completely the exhaust
must be removed.
(Estimated Replacement Time: 10 minutes)
1. Remove external ducting.
2. Remove the front top lid. Refer to
Top Lid, on page 5-6.
3. Open the lamp door. Refer to
on page 5-8.
4. Remove lamp (if installed). Refer to
Lamp Replacement, on page
5. Remove the rear right skin. Refer to
LPS Cover, on page
6. Remove the two screws securing the rear lid to
the chassis. (Figure 5-11)
5-10
screws from the top of the
™
5.5.1 Front
5.5.7 Lamp Door,
5.13.5
5-38.
5.5.8 LVPS/
5-9.
Figure 5-10 Access Panel Frame
Figure 5-11 Rear Lid
CP2230 Service Manual
020-100562-06 Rev. 1 (05-2016)