Table of Contents
Advertisement
5.4.9 PIB3G/ICP Cover
(Estimated Replacement Time: 2 minutes)
Remove the PIB3G/ICP cover to access the projector's
communications panel.
1. Push down on the cover's center tab. (Figure 5-8)
2. Lift the cover up just enough for the bottom tabs to
clear the frame and remove.
3. When installing the cover, insert the tabbed end
first then lift the cover until top tab clips into place.
5.4.10Access Panel Frame
(Estimated Replacement Time: 8 minutes)
The Access Panel Frame is located on the operator's side
(right) near the front of the projector. To access the
components in the cardcage and light engine compartments
the access panel frame must first be removed.
1. Remove PIB3G/ICP Cover (Figure 5-8).
2. Remove the light engine air filter cover (including filter)
(Figure 5-11).
3. Remove the four, #2 Phillips
access panel frame securing it to the chassis
(Figure 5-9).
4. Tilt the access panel frame a little to the front (lift left
side) to clear the LVPS/LPS cover and remove.
5. Reverse instructions to re-install access panel frame.
D4K25 Service Manual
020-100880-01 Rev. 1 (06-2012)
screws from the top of the
™
Section 5: Parts and Module Replacement
Figure 5-8 PIB3G/ICP Cover
Figure 5-9 Access Panel Frame
5-9
Advertisement
Table of Contents
